New Dual-Heat Monster-Ram Intake — The Cold-Start Fix 6.7L Cummins Owners Have Been Waiting For

Cold starts have been the Achilles heel of the 6.7L Cummins Ram for years. The factory intake manifold is not heat-capable, which means on cold BC mornings your truck is cranking and struggling before it ever fully fires. Gale Banks and Brad Hunt from ProTech Diesel Center in Kamloops sit down to unbox the solution — the new Dual-Heat-Capable Monster-Ram Intake. This is an engineering fix that addresses a real-world reliability problem that diesel owners in cold climates deal with every winter.

What Is the Monster-Ram Intake?

The Monster-Ram is an oversized intake manifold replacement for Ram 6.7L Cummins trucks (2007–2024). Compared to the factory unit, the Monster-Ram flows significantly more air, improving throttle response, reducing EGTs, and supporting higher power levels under load. The new Dual-Heat version accepts two heat sources simultaneously, eliminating cold-start failures that many 6.7L owners experience in temperatures below freezing.

What's In the Box

  • Monster-Ram manifold (cast aluminum construction)
  • Dual-heat port provisions for two heating elements
  • All required hardware and gaskets
  • Step-by-step installation guide

Power and Performance Gains

  • Increased airflow over the factory manifold
  • Lower intake air restriction under boost
  • Improved throttle response, especially loaded or towing
  • Lower EGTs at highway speeds and during tow hauls

Is It Right for Your Truck?

If you run a 2007–2024 Ram with a 6.7L Cummins and you've ever had a rough cold start or want to maximize airflow on a performance build — yes. ProTech Diesel Center in Kamloops stocks and installs Monster-Ram intakes and can pair the install with a custom tune.

Frequently Asked Questions

Q: What trucks does the Dual-Heat Monster-Ram fit?
A: 2007–2024 Ram trucks equipped with the 6.7L Cummins diesel engine.

Q: Does the Monster-Ram require a tune?
A: Not required, but strongly recommended to maximize the performance gain.

Q: How long does installation take at ProTech Diesel in Kamloops?
A: Typically 3–5 hours in our shop. Book at protechdieselcenter.com.

Q: Will the Monster-Ram fix my cold-start problem?
A: The Dual-Heat Monster-Ram significantly reduces cold-start failures. Also inspect your grid heater system — a failing grid heater bolt is one of the most common root causes.

Q: How much does installation cost?
A: Contact us directly for a current quote on your specific truck.